Easidew I.S. User’s Manual
2
97099 Issue 13.4, August 2015
INSTALLATION
2
INSTALLATION
2.1
Unpacking the Instrument
On delivery, check that all the following standard components are in the packing tube:
•
Easidew I.S. Transmitter
5/8” UNF and G 1/2” BSP version - Bonded seal fitted over threaded part of
transmitter body
OR
3/4” UNF version - Recessed sensor O-ring seal
•
Quantity 3 cable crimps
•
Sensor connector
•
Packing tube, and foam protectors (not needed for operation - save all
the packing materials for the purpose of returning the instrument for re-
calibration or any warranty claims)
•
Certificate of calibration
NOTE: If any component is not present in the packing box, contact Kahn
Instruments immediately.
Unpack the dew-point transmitter packing tube as follows (see
Figure 1).
G
1/2
“
BSP (black)
3/4”
UNF (green)
5/8”
UNF (blue)
9
8
7
6
4
5
3
2
1
Figure 1
Transmitter Unpacking Method
1.
Unscrew the cap (1) from the packing tube (9).
2.
Remove the bag containing 3 cable crimps (2).
3.
Remove the foam block (4) containing the connector (3).
4.
Pull out the transmitter (6) from the tube, complete with the two foam
covers (7) and (8) and the red protective cap (5).
5.
Remove the foam covers from the transmitter but leave the green, blue or
black plastic protective cover (6) and the red cap (5) in place until ready
for installation.
NOTE: The transmitter sensing element is protected while in transit by a black,
green or blue cover containing a small desiccant capsule. The connection pins
are protected by a red plastic cap. None of these plastic items are required for
the operation of the transmitter.
NOTE: Keep the connector (3) in a safe place until the transmitter is ready
for wiring.
