Cleaning the filter element with compressed air
1. Release the retaining clip and take off the cover.
2. Withdraw the filter element.
3. Use dry compressed air (<5 bar!) to blow dirt from the air filter cartridge at a slant from the in‐
side to the outside.
4. Inspect the air filter element for any damage.
Change the air filter element if damaged.
5. Clean the housing and sealing faces.
6. Replace the filter element.
7. Position the cover and close the retaining clips.
8. Switch on the power supply disconnecting device.
10.6 Option H10
Air filter (plastic housing) maintenance
Check that all sealing surfaces match each other. The use of an unsuitable air filter cartridge can
permit dirt to ingress into the pressure system and cause damage to the machine.
Material Compressed air for blowing out
Spares as required
Precondition Cut-off the electrical power supply via the power supply isolating device,
ensure that the device is locked off,
verify the absence of any voltage.
The machine has cooled down.
Fig. 30 Option H10: Air filter (plastic housing) maintenance
1
Cover
2
Air filter cartridge
3
Air filter housing
Cleaning the filter element with compressed air
1. Unscrew and remove the cover.
2. Withdraw the filter element.
3. Use dry compressed air (<5 bar!) to blow dirt from the air filter cartridge at a slant from the in‐
side to the outside.
10 Maintenance
10.6 Air filter (plastic housing) maintenance
68
Assembly and operating manual 2-stage piston compressor
EPC-2-G
No.: 9_5753 24 E
