KCH Series Hand-type Ultrasonic Plastic Welding Machine
Weihai Kaer Sonic Power Co., Ltd. www.kaer-welder.com [email protected]
- 8 -
pollution;
8. Proper ventilation facilities should be made available when processing noxious
plastic parts or those with peculiar smell,
9. Stop and check the machine immediately in case any abnormal noise occurs or
transducer system heats to over 50 during operation. Only after returning to
℃
normal can the production be continued; If temperature of transducer system is
still on the high side, continuous operation shall only be allowed after cooling it
down. In special situation, forced heat-elimination measures should be taken.
10. If fuse of the machine is blown, a fuse with regulated nominal value should be
adopted. If fuse is blown for several times, the machine should be stopped
immediately for inspection. Only after an error (errors) is located and proper
repairing is conducted can it be put into application;
11. Remove dust from electric cabinet regularly after a long time operation; if
equipment is not used, proper dust cover should be chosen to cover them;
12. If heat emission fan gets blocked from running, stop immediately for inspection.
Continuous use will not be allowed until normal condition is resumed;
13. Special staffs shall be designed for debugging and maintaining the equipment;
14. Please feel free to contact us should any error occurs. No continuous use or
optional alteration is allowed.
15. Press the operational button with both hands for operation. Foot operated switch is
not available for this machine. Any consequences resulting from self-modification
or self-setting shall not be our responsibility.
VI. Troubleshooting for Frequently Asked Questions and
Equipment Maintenance
1. When turning on power switch, power indicator doesn’t light and fan doesn’t run,
and no response is seen to operation, then possible causes are as follows:
a. No electricity for power source, please check to confirm;
b. Bad contact between power line and outlet, please make due repairing;
c. If fuse of equipment power supply is blown, please change fuse with regulated
nominal value.
2. If non-logic action is found, please make inspection as suggested below. Contact
our service staff if it still can’t be solved.
a. Check if connection of logic cable conductor is normal;
b. If control handle is well connected;
3. In the event of unstable logic control, check and handle it as follows. If not
successful, please contact our service department in case of failure.
d. Caused by the interference due to too close distance between the logic wire
and the power output wire.
