25
© 2017 Infinite Electronics, Inc., All Rights Reserved.
1. Channels Menu. Set parameters for this measurement channel. See section 1.13
2. Add and delete measurement tags menu. See Section 1.22.6
3. Traces menu. Add and edit traces to the display. See Section 1.12
4. Reset scales. Reset zoom settings. See Sections 1.14.1,1.14.2
5. Show/Hide Button Labels.
6. Display for Start/Stop Stimulus Frequency.
7. Display for the number of plot/measurement points. Edited via the Trace menu. See Section 1.12
8. Edit Mode name.
9. Add measurement markers (Long press), Change highlighted marker on the selected trace (Short press).
10. Trace Memory on/off. See Section
11. Move highlighted marker.
12. Calibration indicator.
13. Enter the State Files menu. See Section 1.23
14. Switch between single or continuous sweep.
15. Start/Stop trace/measurement.
16. Record (Record display for a report)
17. Record Progress Icon appears as the trace sweeps.
18. Spec limit display.
19. Trace Pass/Fail indicator
20. Picture Menu. See Section 1.22.3
1.16 Cable Loss Measurement
Cable loss is measured by measuring return loss to a shorted end of the Cable under test, then halving that loss to find
the cable loss. First do an OSL (Open Short Load) calibration on the iVA , See Section 1.10.1.1
. Then fit the iVA to one
end of the cable under test and the OSL short to the other end of the cable under test.
1.17 Transmission Measurement
Signifies this feature is locked. See your Kaelus dealer to add this feature.
Transmission mode allows you to characterize insertion loss between two or more points. For transmission mode between
2 and 4 iVA’s need to be connected. See Section 1.9, allow each Bluetooth device to communicate with the Kaelus iVA
Application. Make note of the ports each iVA is connected to. Setup the transmission traces required between the ports
in the traces menu. Once the traces have been created. Calibration items will appear in the calibration menu to Calibrate
between the ports you have selected in your transmission traces. Calibrate using an N type through connector. The iVA’s
that need to be connected together will flash their Tx and Rx LED’s when the Calibration item is selected.
