MEASURED ELECTRICAL PARAMETERS
(dc
current
, dc
voltage
, dc
power
, dc ener
gy
)
able to perform measurements in
kV, A, kA, W, kW, MW, GW, kWh, MWh, GWh
units
SHORTCUT KEY PROPERTIES
Allows entry to energy display unit
.
By presing
▼
key
export, import, net (
difference
)
and total energy values may be accessed
.
Returns to main screen by pressing
SET
key
.
+
:
:
device number is displayed for 3 sec. in models with
RS485
properties
:
operation time of the device is displayed for
3
sec
+
SET
:
operation duration of the device with positive current is displayed for
3
sec
+
SET
:
operation duration of the device with negative current is displayed for 3 sec
If Latch function is selected in models with alarm properties, alarm should be absolutely deleted by pressing
set key.
If pressed for 3 sec. It goes to parameter and settings menu.
SET
:
Export ener
gy I
mport ener
gy
Net ene
rgy
To
tal
ener
gy
Export ene
gy
= Po
sitive
Ener
gy
I
mport ene
gy
= Negati
ve
Ener
gy
Net ener
gy
= (Po
sitive
Ener
gy
) - (Negati
ve
Ener
gy
)
To
tal
ener
gy
= (Po
sitive
Ener
gy
) + (Negati
ve
Ener
gy
)
SET
Main screen
ENTRY TO PARAMETERS
If set KEY is pressed for 3 sec. password should be entered before entry to parameters menu. At this stage, HHHH is displayed in the line at the bottom of the screen while the password
screen flashes. When SET key is pressed, 0000 figures are displayed in the most bottom line and the screen begins to flash more rapidly. The flashing figures can bet set with ▼and ▲keys
and next digit can be entered by pressing SET key. When all digits are completed, if the password is correct the first parameter Clear Energy (CLR energy) section may be entered. If the
password is incorrect, the device returns to main measurement screen without entering to settings. The default value of the password is 0000. The user can change it.
SET
Blink
SET
Full scale setting of the current
(1 – 50.000A)
Shunt resistance setting
(50 – 100 mV)
YES :
Clear energy
NO:
Not clear energy
SET
SET
SET
Paramet
ers
CLEAR ENERGY
CURRENT FULL SCALE SETTING
SHUNT RESISTANCE mV SETTING
This is where the line current maximum value is set. For ex: if
1000A/60mV
shunt is used
,
then this value should be set as
1000
A.
This is the section where shunt resistance
mV
value can be set
.
For ex: if
1000A/60mV
shunt is used, then this value should be set
as
60
mV yapılmalıdır.
This is where all energies can be cleared
.
In this case, pulses that are to be transmitted in the pulse output are
also cleared
.
Note :
Energies are reset when factory settings are enabled
.
