‘FlexControl 14’ page 8/11 Firmware version 1.x
Suggested configuration of digital input pins, depending on the type of activators, attached to them
↓ - On falling edge
↑ - On rising edge
In the ‘Options’ tab, You may adjust the following parameters:
-
Startup delay, [ms]
: It may be useful if Your tube amplifier needs
warmup. The device will not switch the outputs during that period. In
milliseconds.
-
Always start with last output states
: Check this if You want the
FlexControl to memorize the states of the outputs, so at the next
powerup to start where You left.
-
Reset range calibration of analog inputs
: Relevant only for input pins,
which are configured with analog function. Check this box when
changing the potentiometers, connected to the analog inputs.
-
Use mutex memory
: enables memorization of non-mutex digital outputs (if there are any) against
currently active mutex output. When the same mutex output gets active again, the rest of the outputs
will be restored automatically.
-
MIDI Rx channel:
Defines the MIDI channel to ‘listen’ for incoming messages.
Activator
Class
Type
Desired output
interdependence
Output reactions
↓
Set
Mutex
↑
None
↓
Toggle
Non-
retentive/
momentary
Pushbutton
No
↑
None
↓
Set
Switch
(visible state)
No
↑
Clear
↓
Toggle
No
↑
Toggle
↓
Set
Switch
(invisible state)
Mutex
↑
Set
↓
Set
Retentive
Rotary switch
Mutex
↑
None
