Kaden KJR-120N, Manual

Page: 7 / 24

Kaden Wired Controller Manual | 7
4. Remove the upper part of the
wired controller
Insert a slotted screwdriver into the slots in the lower part of the
wired controller (2 places), and remove the upper part of the
wired controller.
WARNING
The PCB is mounted in the upper part of the wired
controller. Be careful not to damage the board with the
slotted screwdriver.
5. Fasten the back plate of the wired controller
For exposed mounting, fasten the back plate on the wall with
the 3 screws (ST3.9 x 25) and plugs. For flush-mounting, fasten the back plate on the switch box
with 2 screws (M4 × 25) and fasten it on the wall with 1 screw
(ST3.9 x 25).
WARNING
Put on a flat surface. Be careful not to distort the back plate of the wired controller by over-tightening the mounting screws.
6. Battery installation
• Put the battery into the installation site and make sure
the positive side of the battery is in accordance with the
positive side of installation site.
(See figure opposite.)
• Please set the time during first operation. Batteries in the
wired controller can fail during a power failure. When power
is restored, if the time displayed is not correct, it means the
battery is dead and requires replacing.
Slots
Back plate
Screws ST3.9*25)