Kaden Wired Controller Manual |
5
2. Accessories
Select the installation location
Do not
install in areas that contain oil, vapour or sulfureted gas, otherwise, this product can deform which could permanently
damage the product.
Preparation before installation
1. Please confirm that you have all the following parts.
No.
Name
Quantity
Remarks
1
Wired controller
1
2
Wired controller manual
1
3
Screws
3
ST3.9*25 (for mounting on the wall)
4
Wall plugs
3
For mounting on the wall
5
Screws
2
M4X25 (for mounting on switch box)
6
Plastic screw bars
2
For fixing on switch box
7
The connective wires group-1
1
Optional
8
The connective wires group-2
1
Connect to mainboard
9
Battery
1
2. Prepare the following assemblies on the site..
No.
Name
Quantity (embedded into wall)
1
Switch box
1
2
Wiring tube (insulating sleeve and tightening screw)
1
Precautions
1. This manual explains the installation requirements for the wired controller. Please refer to the wiring diagram of this installation
manual to correctly wire the controller to the indoor unit.
2. The wired controller operates in a low voltage loop circuit.
Do not
directly connect the cable to 220V-240V power or 380V high
voltage power.
Do not
wire in a loop; wiring clearance between configured tubes should be at the range of 300mm – 500mm
or above.
3. The shielded wire of the twin shielded signal cable used for the wired controller must be grounded.
4. Upon completing the wired controller connection,
do not
use a mega to measure the insulation as this may cause damage to
the controller.
5. The connective twin shielded signal cable of the wired controller should not be longer than 20 meters.
Summary of Contents for KJR-120N
Page 1: ...Wired Controller Manual KJR 120N...
Page 2: ...2 Kaden Wired Controller Manual...
Page 23: ...Kaden Wired Controller Manual 23 Notes...
Page 24: ...kadenair com au...
