ENG-22
13
Remove/Replace Wind Shutter-2
The Wind Shutter-2 is included in the
package as the standard accessory. This
accessory is intended to reduce the
introduction of wind from chin area while
riding. It can be attached and detached
as desired according to seasons and
intended applications.
4.Put the interlining so such extent that
the edge of the frame rubber is almost
flat with the Wind Shutter-2. The
attachment of the Wind Shutter-2 is
complete (Fig.4).
– How to install Wind Shutter-2 –
1.Refer to Fig.1 and check the front side
and back side of the Wind Shutter-2.
Wind Shutter-2
Wind Shutter-2
Put the interlining into the insdie of the rubber
trim form both sides towards the center by
hands.
Put the interlining into the insdie of the rubber
trim form both sides towards the center by hands.
CAUTION!
•Install the Wind Shutter-2 securely.
Insecure installation may cause falling
of the Wind Shutter-2 while riding.
•Do not use an adhesive agent or similar
items but install the Wind Shutter-2 according to the procedure given above.
Some components of an adhesive agent may damage the material of the helmet.
Fig.1
Fig.2
Fig.3
Fig.4
Fabric side
Sponge side
(Front)
(Back)
Interlining
Fabric side
Cheek pad
insert in-between
Cheek pad
Rubber trim
(front)
Rubber trim
(front)
Rubber trim
(front)
insert in-between
Installation is complete
ENG
2. As shown in Fig.2, turn the helmet
over and attach the Wind Shutter-2 on
the front (chin area) of the helmet. IN
doing this, insert the interlining of both
sides of the Wind Shutter-2 in-between
the front area of the cheek pad and the
rubber trim.
3. As shown in Fig.3, insert the interlining
of the Wind Shutter-2 uniformly into the
inside of the rubber trim from both sides
towards the center.
Summary of Contents for Japan RT33
Page 29: ......
