User manual HRE-serie version 6, November 2013
13
4.2 Starting your system
When everything is connected follow the procedure below:
1. Connect the boiler to the power supply. The 230 VAC will
need to be connected for the 230 VAC Switch the boiler
on with the on/off switch on the dashboard. The lamp in
the switch will indicate that the system is active.
2. Set the required boiler temperature between 65 and 90°C
using the boiler thermostat.
3. Set the room thermostat so that it is switched on (see
manual of the room thermostat)
4. Starting of the oil burner (see figure 10):
4.1. Open the valve in fuel line (5);
4.2. Install the bleed hose (3C) on the bleed opening of
the oil filter;
4.3. Open the valve on the oil filter (5A);
4.4. Start the oil burner;
4.5. The burner switches on, this will take approximately
1,5 minutes because of the oil pre-heating element;
4.6. Open the bleed valve on the oil filter (3B);
4.7. Check if oil is coming out of the hose(3C);
4.8. Check all oil connections for leaks;
4.8.1. If the burner does not start, the control light will
light;
4.8.2. Close the bleed valve (3B) on the oil filter;
4.8.3. Wait approximately 3 minutes;
4.8.4. Reset the burner by pushing button and return to 5.4 (repeat if necessary).
4.9. Close the bleed valve(3B) when only oil and no bubbles come out of the hose;
Attention:
The oil burner is tested by the manufacturer, not adjusted. The adjustment of
the burner has to be done by an experienced installer, because this
requires expert knowledge. To be eligible for warranty, the boiler has to be
adjusted by an approved installer. Contact your Kabola supplier to make an
appointment.
Never adjust the burner using your own initiative.
5 Operating the boiler
When the boiler has been started and adjusted according to 4.2, operation fo the boiler is very simple.
The required temperature is set with the room thermostat, which controls the boiler. The calorifier
thermostat controls the boiler. The operation of the room thermostat is explained in the manual of the
room thermostat.
If problems arise with the operation of the boiler, you will find a list of possible problems and solutions
in Appendix C.
Figure 12
