Kaba E-PLEX, Installation Instructions Manual

Page: 15 / 24

15
C-4 Position the strike against the door frame
and align it with the mounting screw holes.
Then mark the outline of the strike.
C-5 Remove any material from within the strike
outline (a) so that the strike will be flush with
the door frame.
C-6 Install the strike using the screws
provided.
D. INSTALLING OUTSIDE UNIT
ASSEMBLY
Note : Ensure that the mounting hole for the
red collars is cleaned out so that the collars
are not crushed upon installation. If necessary,
the hole can be opened up to
5
⁄
16
".
D-1 For door thickness of 1
3
⁄
4
" – 2", insert the
short square spindle (G) into the outside
housing hub. Door thickness of 2
1
⁄
8
" – 2
1
⁄
4
",
insert the long square spindle into the
outside unit hub.
D-2 If your lock comes with a thumbturn,
insert the end of the thumbturn spindle
(F) into the small spindle hole in the outside
housing.
D-3 Place the outside housing on the door so that the bottom spindle engages
the hub on the mortise, and the top thumbturn spindle passes through the
mortise top hub. The outside unit assembly (c) will rest flush against the
door. Ensure the red collar is seated into the top left mounting hole.
E. INSTALLING INSIDE UNIT ASSEMBLY
E-1 Place inside mounting plate flush against the door as
shown. For door thicknesses 1
3
⁄
4
" – 2" insert diagonal-
ly (as shown) two 2
1
⁄
16
" Phillips flat head screws (sup-
plied in STD door kit). For door thickness 2" – 2
1
⁄
4
"
insert diagonally (as shown) two 2
3
⁄
8
" Phillips flat
head screws (supplied in thick door kit).
Note : The screws must correspond to the two
through holes in the mortise.
a
G
F