Revision level 16.09.04
Kaba Mauer GmbH – Frankenstr. 8-12 – D-42579 Heiligenhaus – Tel.: +49/2056/596-0 – Fax: +49/2056/596-139 – www.kaba-mauer.de
Mounting instructions 70171 Varios E
•
In cases where the Kaba Mauer key guide is are not used, the maximum cross sectional area of the keyhole in the door of
the secure storage unit and/or the lock armour plating may not exceed the dimensions given in Fig. 2 considering DIN
2768-mH.
Fig. 2: Max. cross sectional area of keyhole
•
For installation and adjustment of the lock on the door, make sure that the key can be inserted into the lock without
having to apply force and without jamming. This can be achieved by mounting the lock according to the following
pattern of mounting holes (Fig. 3). For further lock dimensions please refer to the Kaba Mauer Catalogue Sheet.
41
49
66,7
Fig. 3: Fastening hole pattern
Technical data:
•
Lift height of bolt 12 mm
•
Bolt in fully extended position: approx. 14 mm
•
The maximum allowable force acting on the key bolt against the blocking direction, the maximum locking force and the
lateral load acting on the bolt, correspond to 1 KN and should not exceed this value. Provision should be made design wise
for bolt stoppers on both ends or for a bolt support.
•
The actuating turning moment on the key may not exceed 2.5 Nm
•
Fastening of the boltwork: via two M4 threads on the front end of the bolt head
•
Optional fastening of the boltwork: via an adapter plate with drift pin in the bolt head
Elektronische Freigabefunktion
Time delay, four-eye identification, remote release 4 wire cable, 250 mm, cable end stripped and tined
Interface
Functional elements
Specification
Cyclic duration
Input
Release magnet (red/black)
563 ohms, Umin=5V DC
5 – 12V: 100% ED / 24V: 87
Output
Key switching contact (orange / brown)
normally open contact,
50 mA, 30V DC
Varios E
X (mm)
Y (mm)
70171
11,5
11,5
7,5
ma
x.
O
12
ma
x.
max. X
max. Y
