Page 38
82132 Code-Combi B
Kaba Mauer GmbH
GB
4.7.1 Opening
1) Insert the Allen key (2 mm) provided into the rear hole (see fi gure 1)
2)
Loosen the screw inside from the shaft mounting, but do not completely unscrew it
(see fi gure 3)
3) Pull out the bar handle with the drive shaft (square end) (see fi gure 2)
4)
If the shaft mounting (see fi gure 3) covers the keyhole, pull out Allen key. Adjust the
shaft mounting with the aid of the drive shaft (square end) so as to reveal the keyhole
5) Insert key and turn clockwise until stop position reached (key cannot be removed)
If the code needs to be changed, proceed as follows. A penalty time activated has to
elapse before a new primary code can be programmed in.
6) Press
ON
7) Press
P
8) Press
P
9) Press
0
1 x
10) Press
ON
11) Press
P
12) Enter new 6-digit primary code
13) Enter new 6-digit primary code once again
14) Turn key anti clockwise until stop position reached and remove it
If the new code as per 13) was incorrectly confi rmed, the signal
3 x
appears.
Repeat the sequence.
By pressing the key combination
P
and
0
all the functions programmed (secondary code,
dual code, time delay, opening window) are deleted.
4.7.2 Locking
1) Turn key counter clockwise until stop position reached
2) Remove key and keep in a safe place
3)
Turn the shaft mounting back to the original position with the aid of the drive shaft
(square end). The position of the screw in the shaft mounting must be turned towards
the drilled hole in the input unit provided for the Allen key (see fi gure 3)
4)
Replace the bar handle in the original position. The screw in the bar handle must be
turned towards drilled hole in the input unit provided for the Allen key
5)
Turn the screw tight into the shaft mounting using the Allen key (secure drive shaft and
bar handle against being pulled off)
6) Remove Allen key
