background image

Document Number 384.120  Rev. C2 - 01/02

www.kaba-mas.com

749 W. Short Street, Lexington, KY 40508

Phone (800) 950-4744 or (859) 253-4744 FAX (859) 253-4748

Battery Replacement

Read all instructions before attempting to replace the battery in an LC Series
lock.

To replace the battery, you must
first remove the keypad
assembly. To do so, insert the
blade of a flat head screwdriver
under the keypad housing at a
point about 15 degrees to the
right of 6 o’clock on the face of
the keypad (below the Enter
key). (See Figure 1.) There is a
small indentation on the back
edge of the keypad housing that
will allow the screwdriver to
easily be inserted at this point.
Pry the keypad assembly from
the face of the safe being
careful not to damage the cable
connection from the safe to the
keypad assembly. (See Figure
2.)

Remove the old battery and
replace with a new 9-Volt
battery. (See Figure 2.) Reattach
the keypad 

being careful not to

pinch the battery cable
between the keypad housing
and the mounting bracket

.

Test the operation of the lock
before closing the container. If
the combination is entered
successfully, one green flash
displays to indicate the lock is
ready to open. Then rotate the
container handle to retract the

bolt. If  the test is successful, the
lock and container are now
ready for use.

Note:

If the lock does not operate successfully, carefully remove the keypad, check

the cable connection, and verify that all mounting screws are securely tightened.

Insert Blade of

Screwdriver

Under Keypad

Housing

Figure  1

Battery Clip

Cable
Connection

Figure  2

Battery

Reviews: