Digital Lock Set
SL7000 Series
Digital Lock Set
Installation Instructions
Digital Lock Set-Changing the Code Number
6. Spindle Spring
7. Mortice Lock - 60mm Backset with
Strike Plate, Fixing Screws x 5,
Cylinder Retaining Screw x 1
8. Euro Profile Cylinder with 2 Keys
9. Cylinder Escutcheons
10. Instructions & Template
11. Allen key
5. 8mm Square Spindle (Drive Bar) x 78mm
2. Neoprene Seals x 2
(2 Spare 70mm & 2 Spare 80mm).
3. Digital Interior Code Pad Assembly
1. Digital Exterior Code Pad Assembly
4. Fixing Screws x 2 - 60mm
3
4
4
2
6
2
5
1
Components
* To cancel pull down outside handle and turn the passage knob
back to the 12 o’clock position.
and "Passage Mode is now set to give free access without
from 12 o'clock to 9 o'clock “P” position. Release the handle
* Turn the passage knob of Digital Interior Code Pad Assembly
Pad Assembly to 4 o'clock position and hold the handle in
* Enter correct code, turn the handle of Digital Exterior Code
passage
Digital Lock Set-Passage Mode Function
downward position
.
the need to enter the code.
knob
door engaging the square spindle in the handle hub.
* Screw both side together using the fitting screws top and bottom. (FIG 1)
* Locate the Interior Handle Assembly on the inside of the
square bar engages the hub in the mortice lock assembly.
the spindle bar and spring in position and ensuring that the
Select the fixing screws to suit the door thickness.
* Fit the neoprene seals to both the Exterior Code Pad
* Hold the Exterior Code Pad Assembly onto the door with
and Interior
Handle Assemblies.
A LOCKOUT BEFORE CLOSING THE DOOR.
NOTE: CHECK THAT THE CODE WORKS TO AVOID
DO NOT overtighten the fixing screws-this may cause
* Test the mechanism to ensure that the lock functions
* Before tightening of fixing screws make sure the lock is vertical
7) Mounting the Lock
FIG 1
distortion and lead to poor operation.
correctly and moves easily.
Assembly
Interior Code Pad
9
8
7
code
select
buttons
11
1) The digital lock is supplied with factory setcodes: C13579
2) Depress the code select button and slide the selector
from “NON CODE” to “CODE” position and the active
number is selected as shown by the RED indicator.
3) Any numbers not required to be part of the active code
should have the code selectors parked in the
“NON CODE” position.
4) The “CLEAR” button MUST always be used as the
first digit of a code.
5) For best security the code number selected should
contain 4 or 5 digits.
6) Check that the new code works before installation.
NOTE: THE CODE IS NON-SEQUENTIAL
MAY BE ENTERED IN ANY ORDER
Q
25
07
8
03
12
-2
