How to set up the scooter
Assembly of the scooter
MAKE SURE THE KICKSTAND IS UNFOLDED BEFORE PREPARE THE
FOLLOWING CONFIGURATION:
1.
Position the handlebars using the stem in line with the steering column.
2.
Tighten the 4 screws of the stem tight as possible.
ADJUST THE FOLLOWING ITEMS ACCORDING TO YOUR DRIVING
PREFERENCE:
• dashboard support
• the dashboard switch
• the accelerator and the lighting stalk
Then screw them in properly using the supplied tool kit.
HANDLING THE SCOOTER AFTER COMMISSIONING: if the scooter is still in the folded
position, we advise you to move it with the help of a second person, holding both
ends of the vehicle to lift it if the scooter is unfolded, place your two hands on the
two handlebar grips, then you can move it by pushing it while walking beside it once
the assembly is complete, you can start the scooter making sure you have folded the
kickstand. Place one foot on the platform and move forward by pushing forward on
the ground with the other foot without using the accelerator. And make sure that
both hands are positioned on the brake levers. You must reach a speed of 4 km/h
for the vehicle to start.
USER MANUAL - EN 53
52 USER MANUAL - EN
Your tires are fitted with pressure valves. Use them to re-inflate your tires to
a maximum of 36; 45 or 50 psi (depends the model). This information is
written on the side of your tire.
Any repair must be carried out by a professional and / or official distributor
of the KAABO brand.
Never perform maintenance on the displayed battery is on or charging.
Clean any stains from your scooter with a damp cloth.
Do not use alcohol, gasoline, kerosene, or other corrosive and volatile
chemical cleaners.
Do not wash off with water.
Make sure that the scooter is switched off and unplugged during cleaning
and that no water drop or trace of moisture enters the charging port.
If any of the items mentioned are missing, immediately contact the store where you
purchased this scooter.
Maintenance of the scooter
