For Professional Technical Support call 1-844-242-2475 3
17. Follow all local electrical and safety codes, along with the National Electrical Code (NEC). In addition, all
Occupational Safety and Health Administration (OSHA) guidelines must be followed.
18. The motor of this pump has a thermal protector that will trip if the motor becomes too hot. The protector will reset
itself once the motor cools down and an acceptable temperature has been reached. The pump may start
unexpectedly if it is plugged in.
19. Ensure the electrical power source is adequate for the requirements of the pump.
20. This pump is made of high-strength, corrosion-resistant materials. It will provide trouble-free service for a long time
when properly installed, maintained, and used. However, inadequate electrical power to the pump, dirt, or debris
may cause the pump to fail. Please carefully read the manual and follow the instructions regarding common pump
problems and remedies.
PRE-INSTALLATION
APPLICATION
Submersible sewage pumps and designed for pumping sewage, effluent, wastewater or flooded water with up to 2 inch
solids.
The pump is built with overload thermal protections and auto reset. The pump is equipped with a 1
0’ 3-prong
grounding-type power cord and piggyback-style switch for automatic or manual operation. Ball bearings on motor shafts
never need lubrication.
TOOLS REQUIRED
MATERIALS REQUIRED (NOT INCLUDED)
Thread Tape
2
” Check
Valve
2’’ ABS or PVC
Pipe
ABS or PVC
Cement
(to match the pipe)
2
” 90°
Elbow
Phillips
Screwdrive
r
Flathead
Screwdriver
Safety
Goggles
Tape
Measure
Channel
Locks
Pipe Wrench
Cable Ties
Hacksaw
