K-Mate BTE010, User Manual

Page: 4 / 8

Basic operation
1. Switching on/off BTE010
Remark: In order to save power, BTE010 will switch off automatically if no
devices can be connected after 5 minutes.
2. Pairing BTE010 with a Bluetooth cell phone
You have to pair BTE010 with your Bluetooth cell phone before first use.
Please make sure your cell phone is Bluetooth-enabled. Specific pairing steps
may vary with different cell phones. Please refer to your cell phone user’s
manual for further information. The general pairing steps are as follows:
1) Keep BTE010 and Bluetooth cell phone within 1 meter when pairing;
2) Make sure BTE010 is off, otherwise switch it off first;
3) Press and hold MFB button for about 6 7 seconds, until the red and blue
LEDs are flashing alternately. BTE010 successfully entered pairing mode;
4) Switch on your cell phone’s Bluetooth function and search for Bluetooth
devices. After the search is completed select “BTE010” from the Bluetooth
device list;
5) According to the indication, enter password or PIN No:”1234” and press ”
Yes” or “confirm”;
6) After successful pairing, select “BTE010” from the Bluetooth device list,
and press “connect”. The LED indicator will flash twice every 5 seconds if
connected successfully.
Remarks:
Pairing mode will last 2 minutes. BTE010 will switch to standby mode
automatically if it can’t connect to any device after 2 minutes. If you want to
continue pairing BTE010 with a Bluetooth device, please switch off
BTE010 first and then re-pair according to steps 1
6 mentioned above.
BTE010 can remember 8 paired devices. When the number of devices
exceeds 8, the first one will be replaced.
Every time you switch on BTE010, and it doesn’t connect to any device,
press MFB button once, BTE010 will connect to the last connected device.
Every time you switch on BTE010, it will connect to the last connected
device automatically. If you want to pair it with other devices, please switch
off the Bluetooth function of the last connected devices first and pair
BTE010 with the new device according to steps 1
6 mentioned above.
Function Operation LED indicator Indication tone
Switching
on BTE010 Press and hold MFB
button for 3 5 seconds
Blue LED is on
for 1 second
Four rising tones
Switching
off BTE010 Press and hold MFB
button for 3 5 seconds
Red LED is on
for 1 second Four falling tones
Entering
pairing
mode Make sure BTE010 is off,
then press and hold
MFB
button for 6 7 seconds
Red and blue
LEDs
flash
alternately
Six falling tones