K.M.E. VERSIO VL 750, User Manual, Page: 9 / 28

•
System Menu
Input
(see page 11)
Analog
[switch input to „analogue”]
Digital L
[switch input to „digital left“]
Digital R
[switch input to „digital right“]
Digital L+R
[switch input to „digital left + right“ (=mono signal)]
In this menu item you switch the input to „analogue“ or „Digital L“ or „Digital R“ or „Digital L+R“.
You can reproduce a analogue signal or a digital signal (left or right side) or a digital mono
signal on VL 750 / VL 760.
Analog Link Mode
Direkt Link
[input signal = output signal]
ADC out
[analogue input signal is digitalized on output]
Password
(see page 12)
In this menu item you can enter a max. 8-digit password. If you have entered a password and
activate the “lock function” you must enter the password again to unlock the unit.
LCD Brightness
[adjust brightness of the LCD graphic display]
LCD Contrast
[adjust contrast of the LCD graphic display]
Audio Trig. Level
[adjust threshold for the power mode
„
Audio Trigger”]
Here you set the threshold value, which the pre-set „Audio Trig. Time“ counts down after the
audio signal doesn`t exceed it. If the pre-set threshold is exceeded, the time value counts down
again - that means this function is a posttrigger-function.
Audio Trig. Time
[adjust switch-off time for the Power Mode
„
Audio Trigger”]
•
User Presets
[appears only from preset no. 5 to 8]
Preset Name
[enter preset name, max. 12 digits]
Delay
[adjust delay from 0 – 400m, in 10 cm steps]
LC/Crossover
(high pass)
[crossover function]
Type
(subsonic-filter 12 dB Q=1,2 or 12 dB/octave or 24 dB/octave)
Frequency
This digital filter (crossover) limits the frequency range. You can not deactivate this digital filter.
When you need a full-range audio signal on the output you have to set the frequency to 25 Hz
and choose a type of the low cut filter.
Equalizer 1
[adjust equalizer]
Frequency
Gain
Q
(bandwidth)
Type
Parametric
Low Shelf
With this digital filter you can affect the frequency range by making adjustments of filter
frequency (center frequency), the gain (boost resp. cut) and the Q-factor (bandwidth). If you
adjust the sensitivity (gain) to 0 dB you deactivate this filter. If you choose the type “Low Shelf or
High Shelf” the bandwidth is not activated (you can enter a value for the Q-factor but it is
ignored)!
Equalizer 2
[adjust equalizer]
Frequency
Gain
Q
(bandwidth)
With this digital filter you can affect the frequency range by making adjustments of filter
frequency (center frequency), the gain (boost resp. cut) and the Q-factor (bandwidth). If you
adjust the sensitivity (gain) to 0 dB you deactivate this filter.