K.M.E. VERSIO VL 750, User Manual

Page: 5 / 28

6. Choose your factory preset - play!
To adapt the VL 750 / VL 760 to your reinforcement the unit includes pre-set factory
presets. That means you have to choose the current preset for your application
(e.g. if you use the VL 750 / VL 760 as monitor you have to choose preset no. 4
“VL 750 / VL 760 Mon”).
6.1 Powering up / down
To switch on / off your VL 750 / VL 760, please follow the instructions:
1. Apply power supply connection
(90 - 250 Volt / 50 - 60 Hz) on VL 750 / VL 760 (if the
unit is switched to power mode „Always On“, it is switched on now)
2. Press for 1 second the OK-button – the unit is switched on now (if the power mode
“Last State” is activated, the unit is switched on and muted!)
3. To switch off the VL 750 / VL 760, press for 1 second the left arrow key – now the unit
is muted. After this you have to press for 1 second the OK-button to switch off the
VL 750 / VL 760. If the unit is switched to power mode „Always On“ or the unit is locked,
please disconnect the power supply connection to switch off the VL 750 / VL 760.
Note!
Switch on the VL 750 / VL 760 when the volume pot is turned fully anti-clockwise /
left stop and all connected components are switched on and muted previously to avoid an
unwanted sound reproduction.
Because the VL 750 / VL 760 can be in „lock-function“ for rental purposes that means the
unit may not react on changes on the control panel (depending on adjustment before)
and this can cause an immediate reproduction when switching it on. Therefore it is
necessary to mute all connected devices previously.
After switching on the VL 750 / VL 760 the volume pot should be turned to 0 dB (center
click) with deactivated „lock-function“ to keep a defined signal level and an optimal
controlling (this adjustment is a recommendation).
During power on for the very first time Preset 2 „VL 750 / VL 760 Full“ is loaded! More
information about the initial state you can find on page 3.
6.2 Preset overview
The VL 750 / VL 760 includes four factory presets and four user presets. When switching
on for the first time preset 2 “VL 750 / VL 760 Full” is loaded (a factory preset). You can
load factory presets and change them. How it can be made you will find on page 8 - 10 in
this manual. The menu item „Userpresets“ appears only from preset no. 4 to 8, where you
can set and adjust the parameters like limiter, EQs, delays. The names of the presets
(listed below) refer to the menu navigation of the device.
Factorypresets -
are not adjustable and erasable
Preset 01 „SD7 / SD8 Top“
Preset 02 „VL750 / VL760 Full”
Preset 03 „VL750 / VL760 Linear”
Preset 04 „VL750 / VL760 Mon”
Userpresets -
are adjustable and programmable
Preset 05 „USER Delay“
Preset 06 „USER Fullrg.”
Preset 07 „USER Monitor”
Preset 08 „USER Top”