PAS 100 Operating Manual
Page
5 of 31
Rev. 070807
Rear Panel Description
PAS 100 Rear Panel Controls
PAS 100 Rear Panel Controls
PAS 100 Rear Panel Controls
PAS 100 Rear Panel Controls
Inputs
Inputs
Inputs
Inputs
The input knobs are used to set up the speaker for use with different microphones
and media players. Start with all inputs turned all the way down. When using an
input, turn up the knob until the Input Overload starts flashing red and then turn it
back down until it stops and continue turning it down one more line.
Power
Power
Power
Power
The power switch is used to turn the speaker on and off. When plugged into an
power outlet the speaker will charge in either the on or off position.
AC Light
AC Light
AC Light
AC Light
The AC light glows red when the speaker is plugged into a power outlet. When this
light is red no battery power is being used. It is normal for the red AC light to remain
on when the Power is in the Off position.
On Light
On Light
On Light
On Light
The On light glows green when the speaker is switched on and ready to be used.
Mic In
Mic In
Mic In
Mic In
The Mic In connector is used for plugging in a dynamic microphone. The knob
directly above is used to adapt the speaker for use with different microphones.
Aux In
Aux In
Aux In
Aux In
Media players such as CD or MP3 may be connected to the Aux In connectors. The
knob directly above is used to adapt the speaker for use with different music
players. The Aux In may also be connected to the output of a mixing console.
Rec/Line Out
Rec/Line Out
Rec/Line Out
Rec/Line Out
This output may be used to feed a recording device in order to record the same
sound heard coming out of the speaker.
