jWIN JV-DTV23, Owner'S Manual, Page: 27 / 188

27
EN
Connection of PC
You can adjust horizontal/vertical position, clock, phase, and auto-configure, reset as you prefer.
Press the MENU button and then
D D
/
E E
button to select the Special menu.
Press the G G button and then
D D / E E
button to select the desired picture item.
Press the F F / G G button to make appropriate adjustments.
H-Position / V-Position
This function is to adjust picture to left/right and up/down as you prefer.
Clock
This function is to minimize any vertical bars or stripes visible on the screen background. And the horizontal screen size
will also change.
Phase
This function allows you to remove any horizontal noise and clear or sharpen the image of characters.
Auto-configure
This function is for the automatic adjustment of the screen position, clock and phase. The displayed image will disappear
for a few seconds while the Auto-configuration is in progress.
Reset
This function allows you to return to the good picture reproduction programmed at the factory and cannot be changed.
Note : Some signal from some graphics boards may not function properly. If the results are unsatisfactory, adjust your
monitorÕs position, clock and phase manually.
Press the OK button to store it for the PC monitor picture.
Press the EXIT button to return to PC mode.
PC Setup
To see a normal picture, match the resolution of RGB mode and selection of XGA mode.
WXGA
SPECIAL
() OO }{ OO OK OO MENU
H-Pos. 0
V-Pos. 0
Clock 10
Phase 15
Auto
Reset
Language
CSM
PC Control
WXGA
Set ID