ENGLISH-22
6. Intelligent Screensaver and Standby Function
7. Malfunction & Troubleshooting
Ttry the following troubleshooting suggestions.
With the same function of screen protection and stand-by function as computer,
it will automatically enter into screen protection after three minutes in stop or no disc
state, so as to protect your TV screen. After the screen protection state lasts for 20
minutes, it will automatically enter the stand-by state, then the DVD display doesn't
light, no video output, and the power consumption is greatly lowered, thus service
life of the player can be prolonged. In stand-by state, pressing
key on the remote controller can activate the player back to normal working state.
POWER(STANDBY)
No sound:
MUTE
* Ensure that the player is connected
properly with other systems, such
as power amplifier or TV set.
* Ensure that TV set or power amplifier
is working properly.
* Check if
button of the unit or
TV set is pressed.
* Examine whether the volume of TV
set or player is adjusted to minimum.
No picture:
Ensure that the player is connected
firmly with the other systems, such
as TV set.
Ensure that the TV set is in normal
working state.
Check whether the player is in stand
-by state.
*
*
*
Disc not playing
* Ensure that the disc is placed
correctly. (The label side is facing
up.)
* Ensure that the disc is clean.
Microphone has no sound
MIC Switch
ON.
* Ensure the
set to
* Adjust volume of the microphone
properly.
the player and the remote control.
* Point the remote control at the
sensor on the front panel of the
player.
* Check whether the batteries have
adequate power.
No display or partial display:
* Check whether the disc is scratched
and clean.
* As the player is controlled by
microcomputer, when there is a
trouble, please turn off the power
and turn on the player again after
several seconds. If no error display,
the player can be normally used
again.
No output after turning on:
* Ensure that the interval between
continuous turning-on is not too
short.
* Turn on the player again 10
seconds after it is turned off.
The screen doesn't light, no output
POWER(STANDBY)
* The player may have entered stand-by
state, press
on
the remote control to activate it.
* Turn on again 10 seconds after the
power supply is switched off.
Remote control does not work
* Remove the obstacles between
Summary of Contents for JD-VD504
Page 2: ......
