jWIN JD-VD502, User Manual

Page: 18 / 23

Audio Setup Page:
Speaker Setup
Spdif Setup
Speaker Setup Page
Down mix LT/RT
Stereo
5.1
Front Speaker Lrg Large
Small
Center Speaker Sml Large
Small
OFF
Rear Speaker Sml Large
Small
OFF
Subwoofer ON ON
OFF
There are several setup p ages discussed in the following
material. In the Audio category, there are two main areas:
Down m ix:
Dialog volume:
In LT/RT or stereo output mode, set up this item
to adjust voice, within the range from 0 to 20.
SYSTEM SETUP
SPDIF output:
W hen you have an external audio system (e.g. a Home Theater
System) that can accept digital audio signals via a coaxial or
optical cable, SPDIF should be turned on (see below). Doing
so enables the digital signals that leave the JD-VD502 to be
processed by Dolby and DTS Home Theater systems, among
many other devices that have internal decoders capable of
RAW decoding.
Select SPDIF/RAW when you have a receiver that can decode
the digital signal internally. SPDIF is the preferred option in
most cases. If you don't hear any output, then switch to
SPDIF/PCM.
Select SPDIF/PCM when the unit is connected to a 2-channel
digital stereo amplifier , or equivalent device, which does NOT
have the ability to decode the signal.
Select SPDIF/OFF if you do not have a receiver capable of
processing digital audio.
SPDIF Setup Page:
SPDIF output RAW SPDIF OFF
SPDIF RAW
SPDIF/PCM