XV-NA7SL
12
3.1.3 Removing the traverse mechanism assembly
(See Fig.4 and 5)
Note:
• Prior to performing the following procedure, remove the
clamper assembly and the tray.
(1) Remove the four screws
B
attaching the traverse mechanism
assembly.
ATTENTION:
Before reattaching the traverse mechanism assem-
bly, pass the card wire extending from the spindle
motor board through the notch d of the elevator.
Fig.4
Fig.5
3.1.4 Removing the elevator
(See Fig.6)
Note:
• Prior to performing the following procedure, remove the clamper assembly, the tray and the traverse mechanism assembly.
(1) Extend each bar
e
inside of the loading base outward and detach the elevator shaft.
ATTENTION:
When reattaching, first fit the two shafts on the front of the elevator to the slots f of the slide cam.
Fig.6
