1-16 (No.XA008)
3.2.8
Removing the rack holder assembly/ sensor assembly
(See Figs.23 to 28)
• Prior to performing the following procedure, remove the tray
assembly, side (L)/ side (R) assembly, lifter assembly.
Attention:
If the slide gear of the body places at joint
t
of the rack holder
assembly, turn the gear 1 counterclockwise to move the slide
gear toward the front. Remove the rack holder assembly.
(1) Remove the three screws
J
attaching the rack holder as-
sembly. Release joint
t
from the notch.
Caution:
When reattaching the rack holder assembly, do not nip
the wire
u
extending from the sensor assembly.
(2) Remove the two screws
K
attaching the sensor assembly.
(3) Move the sensor assembly in the direction of the arrow to
release from the slot at joint
v
.
(4) Remove the spring attached to the bottom of the sensor as-
sembly from the boss
w
on the sensor slider.
(5) Remove the screw
L
and
M
attaching the sensor board and
SV resister respectively.If necessary, unsolder the sensor
board.
Caution:
When reattaching the SV resister, attach the sensor slider to
the sensor bracket and fit the lever on the bottom of the SV re-
sister into slot
x
of the sensor slider.
Caution:
When reattaching the rack holder assembly, turn the gear 1
clockwise to move the slide gear and slide lever inside the
body rearward.
• Let the wire extending from the sensor assembly through notch
u
to the bottom of the body.
• Fit pin
y
of the slide lever into hole
z
of the sensor slider on the
bottom of the sensor assembly while attaching the spring to the
boss
w
of the sensor slider.
• Engage joint
v
of the sensor assembly to the notch of the body.
Fig.23
Fig.24
t
J
J
J
Gear 1
Rack holder
assembly
u
t
t
Rack holder
assembly
Rack holder
assembly
Summary of Contents for XV-M5GSL
Page 29: ... MEMO ...
Page 50: ...2 6 No XA008SCH MEMO ...
