(No.MB338)1-21
3.2.8 Attaching the pickup
(See Figs.7, 9 to 12)
• See "3.2.7 Removing the pickup".
(1) Attach the shaft, SW actuator and LEAD spring to the pick-
up. (See Fig.11.)
(2) Align the pickup to the section
m
of the traverse mecha-
nism assembly first, and set the both ends of the shaft of
the pickup in the sections (
j
,
k
) of the traverse mechanism
assembly. (See Fig.10.)
(3) Attach the plate and thrust spring. (See Fig.9.)
(4) Remove the solders from the soldered sections
e
after at-
taching the card wire to the connector on the pickup. (See
Figs.7 and 9.)
(5) Turn the feed gear M in the direction of the arrow 1 to move
the pickup fully in the direction of the arrow 2. (See Fig.12.)
Fig.12
Feed gear M
Pickup
1
2
Summary of Contents for SP-UXQD9S
Page 32: ...1 32 No MB338 SECTION 5 TROUBLESHOOTING This service manual does not describe TROUBLESHOOTING ...
Page 33: ... No MB338 1 33 ...
Page 41: ...2 5 SHEET 4 ...
Page 71: ...3 21 MEMO ...
