JVC RX-E100SL, Instructions Manual

Page: 14 / 42

12
ANALOG
PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
L C R
LS S RS
LPCM
DOLBY D
DTS
ANALOG PRO LOGIC
SUBWFR LFE
VOL
DGTL AUTO
INPUT ATT
DSP
L C R
LS S RS
LPCM
DOLBY D
DTS
Basic Settings
DVD TV VCR CD FM AM
RX-E100 HOME THEATER RECEIVER TV DILECT
DVD
MEMORY
CONTROL
ADJUST SETTING
STANDBY
D I G I T A L
D I G I T A L
S U R R O U N D
INPUT
ANALOG/DIGITAL
INPUT ATT
MASTER VOLUME
SURROUND
ON/OFF
DSP
MODE
ANALOG PRO LOGIC
SUBWFR LFE
SLEEP ST TUNED MUTING
MH
Z
KH Z
VOL
AUTO
DGTL AUTO
INPUT ATT
DSP
L C R
LS S RS
LPCM
DOLBY D
DTS
POWER
CONTROL
5
/
∞
/
3
/
2 Display
SETTING
Setting the Speakers for
DSP Modes
To obtain the best possible surround effect from the DSP (Digital
Signal Processor) modes (see page 22), register the following
information after all connections are completed.
• Speaker Size — FR SP, CTR SP, REAR SP
• Delay Time — CTR DL, REAR DL
• Crossover Frequency — CROSS
• Dynamic Range Compression — D.R.C.
• Low Frequency Effect Attenuator — LFE
Speaker Size — FR SP, CTR SP, REAR SP
Register the sizes of all the connected speakers.
• When you change your speakers, register the information about
the speakers again.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
settings.
2
Press CONTROL
∞
(or
5
) repeatedly until one
of the following speakers (with the current
setting)
*
appears.
Remote
NOT
Setting the Subwoofer Information
When you have connected a subwoofer, follow the procedure below.
If you do not use a subwoofer, you can skip this setting.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1
Press SETTING.
The CONTROL buttons now work for basic
settings.
2
Press CONTROL
∞
(or
5
) repeatedly until
“SUBWFR (Subwoofer)” (with the current
setting)
*
appears on the display.
* “NO” is the initial setting. If you have already changed the
setting, “YES” will be shown.
3
Press CONTROL
3
(or
2
) to select “YES.”
• Each time you press the button, the subwoofer setting
alternates between “YES” and “NO.”
YES : Select this when a subwoofer is used.
The subwoofer speaker indicator (SUBWFR) lights
up on the display (see page 9). You can adjust the
subwoofer output level (see page 19).
NO : Select this when you have not connected or have
disconnected a subwoofer.
Remote
NOT
SETTING
CONTROL
GIC
VOL
UTO
TT
CONTROL
SETTING
CONTROL
EN08-16.RX-E100SL[J]_f 01.3.7, 2:49 PM 12