Page 46
English
IMPORTANT
To operate JVC’s video components using this remote control:
• Some JVC VCR can accept two types of the control signals — remote code “A” and “B.” Before
using this remote control, make sure that the remote control code of the VCR connected to the
VCR1 jacks is set to code “A.”
• When operating the video components, aim the remote control directly at the remote sensor
on the each component.
• When the TV is connected with the AV COMPU LINK cable (see page 42) in addition to the
connections using cables with RCA pin plugs (see pages 9 and 42), aim the remote control
directly at the remote sensor on the receiver to operate the TV.
VCR
After pressing VCR1 or VCR CONTROL (with the remote control mode selector set to the “TV / VCR /
TUNER / CD / DVD / VCD” position), you can perform the following operations on the VCR:
PLAY:
Starts playing.
REW:
Rewinds a tape.
FF:
Fast winds a tape.
STOP:
Stops operations.
PAUSE:
Pauses playing or recording temporarily. To release it, press the PLAY button.
REC
¶
¶
¶
¶
¶
:
Press this button with the PLAY button to start recording.
Press this button with the PAUSE button to enter recording pause (standby).
C/–:
Changes the channels on the VCR.
1 — 9, 0:
Selects the channels on the VCR.
Notes:
• You can use either the VCR1 button or the VCR CONTROL button to activate the buttons listed above. If
you press VCR1, the playing source also changes to “VCR1.” On the other hand, if you press VCR
CONTROL, the playing source does not change to “VCR1.”
• You can also turn the VCR on and off by pressing VCR POWER on the remote control.
DVD player
After pressing DVD or DVD MULTI (with the remote control mode selector set to the “TV / VCR / TUNER
/ CD / DVD / VCD” position), you can perform the following operations on a DVD player:
PLAY:
Starts playing.
4
4
4
4
4
:
Returns to the beginning of the current (or previous) track.
¢
¢
¢
¢
¢
:
Skips to the beginning of the next track.
STOP:
Stops playing.
PAUSE:
Stops playing temporarily. To release it, press the PLAY button.
After pressing DVD or DVD MULTI (with the remote control mode selector set to the “TV / VCR /
TUNER / CD / DVD / VCD” position), these buttons can be used for the DVD menu operations.
Note:
For detailed menu operations, refer to the instructions
supplied with the discs or the DVD player.
TEST
(REAR R)
REAR (L)
5
4
6
2
1
3
8
7
/P
9
CNTR
DELAY
MENU
ENTER
EFFECT
EN44-52.RX-80P[UF]/f
98.8.31, 1:53 PM
46
