(No.MB269)1-9
3.11 Removing the voltage selector board
(See Figs.13 and 14)
• Prior to performing the following procedure, remove the top
cover.
(1) From the back side of the main body, remove the two
screws
P
attaching the voltage selector board. (See Fig.13)
(2) Remove the solders from the soldered sections
d
on the
power transformer board 2. (See Fig.14)
(3) Remove the tie band fixing the wires. (See Fig.14)
(4) Take out the voltage selector board.
Fig.13
Fig.14
3.12 Removing the power transformer
(See Fig.15)
• Prior to performing the following procedures, remove the top
cover and voltage selector board.
(1) From the top side of the main body, remove the tie bands
fixing the wires.
(2) Remove the solders from the soldered section
e
on the
power transformer board 1.
(3) Remove the solders from the soldered sections
f
on the
power transformer board 2.
(4) Disconnect the wire from the connector
CN251
on the pow-
er transformer board 1.
(5) Remove the four screws
Q
attaching the power transform-
er.
(6) Take out the power transformer from the main body.
3.13 Removing the power/fuse board
(See Fig.15)
• Prior to performing the following procedures, remove the top
cover and voltage selector board.
(1) From the back and top sides of the main body, remove the
screw
R
and screw
S
attaching the power/fuse board.
(2) Remove the solders from the soldered sections
g
attaching
the power cord.
(3) From the reverse side of the power/fuse board, remove the
solders from the soldered sections
h
attaching the wires.
Fig.15
Rear panel
P
Soldered sections
d
Power transformer
board 2
Voltage selector
board
Tie bands
CN251
Soldered
section
e
Soldered sections
f
Soldered
sections
g
Soldered
sections
h
Tie band
Power transformer
Power
transformer
board 2
Power cord
Q
Q
S
R
Q
Q
Power
transformer
board 1
Power / Fuse board
