7
■■
Basic operations
Note:
The lighting condition for the STANDBY
indicator and the
display differs depending on the power source.
* If no source is playing and no operation is done for about
4 minutes, “DC OFF” starts flashing on the display for about one
minute before the system turns off automatically (except when
the source is FM/AM or AUX, or when the microphone
(or guitar) is used).
Press
ON/STANDBY.
• When the system is operated on batteries or car battery (DC12V),
press
ON/STANDBY on the system.
The STANDBY indicator goes out when the system is operated on
AC power.
The display comes on and the system is ready to continue in the
mode it was in when the power was last turned off.
Press
ON/STANDBY again.
The STANDBY indicator lights up when the system is operated on
AC power.
• When the AC power is used, the CLOCK indicator and the time
are displayed without backlighting.
■
Some power is always consumed even though power is turned
off (called standby mode).
■
To disconnect the system from mains (AC) supply completely,
unplug the AC power cord from the AC outlet. When you
unplug the AC power cord, the clock will be reset to
“AM12:00” if no memory backup batteries are installed.
You can adjust the volume level between 0 and 50.
Turn the /– control clockwise to increase the volume
or turn it counterclockwise to decrease the volume.
Press to increase the volume or press VOLUME – to
decrease it.
When you press and hold or –, the volume changes
rapidly.
CAUTION: DO NOT start playing any source
without first setting the volume to minimum, as a
sudden blast of sound can damage your hearing,
speakers and/or headphones.
For private listening
Connect a pair of headphones to the PHONES jack on the rear of
the system (see page 6). No sound comes out of the speakers.
Be sure to turn down the volume before connecting or putting on
headphones.
SUPER WOOFER
/–
STANDBY
indicator
/–
ON/STANDBY
ACS ON/LEVEL
indicator
SUPER WOOFER
/–
/–
DISPLAY
ON/STANDBY
SOUND
ACS
SOUND
ACTIVE CLEAR
SOUND
Turning the power on and off
Power source
STANDBY indicator/display
AC power
• The STANDBY indicator lights when
power is turned off.
• Backlighting of the display is illuminated
when power is turned on.
Batteries or car
battery (DC12V)*
• The STANDBY indicator does not light.
• Backlighting of the display is not
illuminated.
• With the system turned off (at standby), no
indication is shown on the display.
Turning on the system
STANDBY
or
On system
On remote control
Turning off the system
Adjusting the volume
Using the system
Using the remote control
STANDBY
or
On system
On remote control
RV-NB1[J]fff.book Page 7 Monday, August 23, 2004 2:28 PM