– 28 –
If you are having a problem with your unit, check this list for a possible solution before calling for service.
If you cannot solve the problem from the hints given here, or the unit has been physically damaged, call a qualified person,
such as your dealer, for service.
Troubleshooting
Symptom
No sound is heard.
Hard to listen to broadcasts because of
noise.
The disc sound is discontinuous.
The disc tray does not open or close.
The disc does not play.
The cassette holders cannot be opened.
Impossible to record.
Operations are disabled.
Unable to operate the unit from the remote
control unit.
Cause
Connections are incorrect or loose.
• Antennas are disconnected.
• The AM loop antenna is too close to the
unit.
• The FM antenna is not properly extended
and positioned.
The disc is scratched or dirty.
• The AC power cord is not plugged in.
• Trays are locked.
The disc is placed upside down.
Power supply from the AC power cord has
been cut off while the tape was running.
Small tabs on the back of the cassette are
removed.
The built-in microprocessor may
malfunction due to external electrical
interference.
• The path between the remote control unit
and the remote sensor on the unit is
blocked.
• The batteries are exhausted.
Action
Check all connections and make
corrections. (See pages 8 to 10.)
• Reconnect the antennas correctly and
securely.
• Change the position and direction of the
AM loop antenna.
• Extend the FM antenna at the best
position.
Clean or replace the disc. (See page 27.)
• Plug the AC power cord.
• Unlock the trays. (See page 18.)
Place the disc with the label side up.
Turn on the unit.
Cover the holes with adhesive tape.
Unplug the AC power cord and then plug it
back in.
• Remove the obstruction.
• Replace the batteries.
Specifications
Amplifier section
Output Power
CA-MXJ300:
100 W per channel, min. RMS, driven into 6
Ω
at 1
kHz with no more than 10% total harmonic distortion.
CA-MXJ200:
60 W per channel, min. RMS, driven into 6
Ω
at 1 kHz
with no more than 10% total harmonic distortion.
Audio input sensitivity/Impedance (at 1 kHz)
AUX IN: 300 mV/50 k
Ω
Speakers/Impedance: 6
Ω
– 16
Ω
Tuner
FM tuning range: 87.5 MHz – 108.0 MHz
AM tuning range: 530 kHz – 1,710 kHz
CD player
CD Capacity:
3 CDs
Dynamic range:
85 dB
Signal-to-noise ratio:
90 dB
Wow and flutter:
Immeasurable
Cassette deck
Frequency response
Normal (type I): 50 Hz — 14,000 Hz
Wow and flutter
0.15% (WRMS)
Design and specifications are subject to change without notice.
General
Power requirement:
AC 120 V
, 60 Hz
Power consumption:
CA-MXJ300:
105 W (at operation)
8 W (on standby)
CA-MXJ200:
95 W (at operation)
9 W (on standby)
Dimensions (approx.): 265 mm x 315 mm x 361 mm (W/H/D)
(10
7
/
16
in. x 12
7
/
16
in. x 14
1
/
4
in.)
Mass (approx.):
CA-MXJ300:
8.7 kg (19.2 lbs)
CA-MXJ200:
7.2 kg (15.9 lbs)
Supplied accessories
See page 8.
Speaker section
T
ype:
2-way bass-reflex type
Speaker units:
Woofer:
16 cm (6
5
/
16
in.) cone x1
Tweeter:
4 cm (1
5
/
8
in.) cone x1
Power handling capacity
SP-MXJ300:
100 W
SP-MXJ200:
60 W
Impedance:
6
Ω
Frequency range:
45 Hz — 22,000 Hz
Sound pressure level: 88 dB/w•m
Dimensions (approx.): 215 mm x 315 mm x 273 mm (W/H/D)
(8
1
/
2
in. x 12
7
/
16
in. x 10
3
/
4
in.)
Mass (approx.):
3.5 kg (7.8 lbs) each
MX-J300/200[J] 20-28 EN
00.4.10, 11:14 AM
28
