(No.MB080)1-11
3.2
Front panel assembly
• Prior to performing the following procedure, remove the front
panel assembly.
3.2.1 Removing the CD switch board
(See Fig. 1)
(1) Disconnect the card wire from the connector
UCW03
on
the CD switch board.
(2) Remove the four screws
A
attaching the CD switch board.
3.2.2 Removing the front board
(See Fig. 1 and 2)
(1) Pull out the sound mode knob, volume knob, and preset
knob from the front side of front panel assembly.
(2) Disconnect the card wire from the connector
UCW02
on
the front board and the connector on the mecha. board.
(3) Remove the fourteen screws
B
attaching the front board.
(4) Disconnect the card wire from the connector
UCW01
on
the front board.
Fig.1
Fig.2
3.2.3 Removing the headphone jack board
(See Fig. 3)
• Prior to performing the following procedure remove the front
board.
(1) You can pull out the headphone jack board.
3.2.4 Removing the cassette mechanism assembly
(See Fig. 3)
(1) Disconnect the card wire from the connector on the mecha.
board.
(2) Remove the six screws
C
attaching the cassette mecha-
nism assembly.
Fig.3
A
B
B
CD switch board
Front board
UCW03
Connector
UCW01
UCW02
Mecha.
board
Sound mode knob
Volume knob
Preset knob
Connector
Headphone
jack board
Mecha.
board
Cassette mechanism
assembly
C
C
C
(fixing the lug wire)
Summary of Contents for MX-GA8
