(No.XE003)1-5
3.1.5 Removing the hinge cover(See Figure 7 ,Figure 8, Figure 9)
(1) Remove one screw
C
and two screws
B
from the hinge
cover.
C :short D :long
(2) Disconnect one card wire from the connector
CON5
on the
main board.
Fig.7
(3) Remove one screw
E
from the bottom of the main unit.
Fig.8
(4) Leave the LCD panel open. Release four tabs
g
on the
hinge cover by slowly inserting a single-slotted or flat
screwdriver into the slot of the battery terminal.
*Please make sure not to damage either the hinge cov-
er or the bottom case when releasing the tabs.
(5) Slowly remove the hinge cover in the direction indicted by
the arrow.
Fig.9
D
D
CON5
Hinge cover
C
E
Tab g
Tab g
LCD Panel assembly
Battery terminal
Hinge cover
Tab g Tab g
Bottom case
