33
Controlling the projector remotely
Controlling the projector remotely
With a proper LAN cable connection and LAN Control settings, you can operate the projector
from a computer using a web browser or PJLink™ application when the computer and the
projector are connected to the same local area network. This projector supports Crestron®
software and PJLink™.
Configuring the
LAN Settings
To access the OSD menu, see
for details.
If you are in a DHCP environment:
1. Make sure the projector and your computer are properly connected to the same local area
network.
2. Go to
SYSTEM SETUP: Advanced
>
LAN Settings
, and press
ENTER
.
3. The
LAN Settings
page is displayed.
4. Press
to select
DHCP
and press / to select
On
.
5. Press
to select
Apply
and press
ENTER
.
6. Please wait for around 15 - 20 seconds, and then re-enter the
LAN Settings
page.
7. The
Projector IP Address
,
Subnet Mask
,
Default Gateway
, and
DNS Server
settings will
be displayed. Note down the IP address displayed in the
Projector IP Address
row.
If the Projector IP Address still does not appear, contact your network administrator.
If the LAN cables are not properly connected, the
Projector IP Address
,
Subnet Mask
,
Default
Gateway
, and
DNS Server
settings will display 0.0.0.0. Make sure the LAN cables are properly
connected and perform the above procedures again.
If you are in a non-DHCP environment:
1. Make sure the projector and your computer are properly connected to the same local area
network.
2. Go to
SYSTEM SETUP: Advanced
>
LAN Settings
, and press
ENTER
.
3. The
LAN Settings
page is displayed.
4. Press
to select
DHCP
and press / to select
Off
.
5. Contact your network administrator for information on the
Projector IP Address
,
Subnet
Mask
,
Default Gateway
, and
DNS Server
settings.
6. Press to select the item you want to modify and press
ENTER
.
7. Press / to move the cursor and then press
/
to enter the value.
8. To save the setting, press
ENTER
. If you do not want to save the setting, press
MENU
.
9. Press to highlight Apply and press
ENTER
.
If the LAN cables are not properly connected, the
Projector IP Address
,
Subnet Mask
,
Default
Gateway
, and
DNS Server
settings will display 0.0.0.0. Make sure the LAN cables are properly
connected and perform the above procedures again.
