JVC LT-48C570, Instruction Manual

Page: 23 / 64

23
Turning the TV On for the First Time
2. Connect the mains cable to the mains socket after
you have completed all the connections.
3. At this stage, the TV switches to standby mode. The
red LED indicator will illuminate on the front panel of
the TV.
4. In standby mode, press the button on the right
bottom panel under the TV frame or on the remote
control to turn the TV on. The red LED indicator will
turn off.
First Time Installation
1. The first time you turn the TV on, it will go straight into the First Time Installation menu.
Please ensure the aerial is plugged in. (If you have already installed the TV using the Quick
Start Guide, please go to the section “Selecting the Input Source” on the next page.)
SCART
Digital Audio Output
(optical)
HDMI1(ARC) HDMI2 LAN RF HEADPHONE
RF coaxial cable
(not included)
OR
To the mains
socket
4 Initial Setup
Chapter
4
Do not connect the TV to the mains
supply until you have completed all the
connections.
• Always disconnect the TV from the mains socket when not in use for a long period of time.
• The button on the right bottom panel under the TV frame or on the remote control is only used for switching the TV
into standby, it does not disconnect the TV from the mains power. To completely disconnect the mains power, please
remove the mains plug from the mains socket.
• This instruction manual explains the basic instructions for operating this unit. Unless otherwise stated, all operations
described are based on remote control use.
• All pictures shown are for illustration purpose only. Actual product may vary due to product enhancement.
• When an item in main menu is displayed gray, it means that the item is not available or cannot be adjusted.
• If you are going to watch TV using a set-top box, simply connect your TV and set-top box via a HDMI cable and select
HDMI in the Input Source menu.
If you are going to watch TV using a set-top box, press the EXIT
button on the remote control then skip this section. Then press the
INPUT button on the remote control to select HDMI mode.
1. Connect one end of the RF coaxial cable to the
aerial socket on the wall and the other end of the
cable to the RF (75Ω) socket at the rear bottom of
your TV.
First Time Installation
Exit EXIT Select OK
WELCOME:
We hope you will be very
happy with your new TV
Please ensure aerial is plugged
in!
Then press [OK] button.