JVC LT-32WX84, Service Manual, Page: 40 / 130

1-40 (No.YA004)
4.7 ADJUSTMENT PROCEDURE
4.7.1 SETTING BEFORE ADJUSTMENT
(1) Check the following settings before adjustment.
(2) Take note of initial values in the following table before adjustment. Then, set the values to adjustment setting values shown in
the following table. After adjustment procedure, return the values to the initial values you have taken note of (except white
balance adjustment).
The values can be set for each input signal (NTSC etc.), but the values are basically the same among the input signals.
Since the values are not adjusted for 525p/750p (because the values change according to the reference adjustment values), you
do not have to take note of the values if unnecessary.
(3) Unless otherwise specified in the adjustment instructions, preset the following functions with the remote control unit:
NOTE:
Follow the order instructed in adjustment procedure.
Item setting value contents
S19 128 R CUT OFF
S21 128 G CUT OFF
S23 128 B CUT OFF
Item
Initial value
NTSC
Initial value
525p
Initial value
1125i
Initial value
750p
setting value contents
S13 255 R DRIVE
S15 255 G DRIVE
S17 255 B DRIVE
Setting item Settings
VIDEO STATUS STANDARD
BRIGHT / CONTRAST / COLOR / TINT 00
COLOR TEMPERATURE
LOW
DIG. NOISE CLEAR OFF
COLOR MANEGMENT STANDARD
NATURAL CINEMA OFF
TREBLE / BASS / BALANCE 00
BBE OFF
A.H.S OFF
A.H.B OFF
ASPECT FULL