32
Warning
• The unit can only be used with a 12 V DC power supply, negative ground.
• Disconnect the battery’s negative terminal before wiring and mounting.
• Do not connect Battery wire (yellow) and Ignition wire (red) to the car chassis or
Ground wire (black) to prevent a short circuit.
• Insulate unconnected wires with vinyl tape to prevent a short circuit.
• Be sure to ground this unit to the car’s chassis again after installation.
Caution
• For safety’s sake, leave wiring and mounting to professionals. Consult the car audio
dealer.
• Install this unit in the console of your vehicle. Do not touch the metal parts of this
unit during and shortly after use of the unit. Metal parts such as the heat sink and
enclosure become hot.
• Do not connect the
wires of speakers to the car chassis or Ground wire (black), or
connect them in parallel.
• Connect speakers with a maximum power of more than 50 W. If the maximum
power of the speakers is lower than 50 W, change the
[AMP GAIN]
setting to avoid
damaging the speakers.
(
21)
• Mount the unit at an angle of less than 30º.
• If your vehicle wiring harness does not have the ignition terminal, connect Ignition
wire (red) to the terminal on the vehicle’s fuse box which provides 12 V DC power
supply and is turned on and off by the ignition key.
• Keep all cables away from heat dissipate metal parts.
• After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. on the
car are working properly.
• If the fuse blows, first make sure the wires are not touching car’s chassis, then replace
the old fuse with one that has the same rating.
Basic procedure
1
Remove the key from the ignition switch, then disconnect the
terminal of the car battery.
2
Connect the wires properly.
See
Wiring
connection.
(
33)
3
Install the unit to your car.
See Installing the unit (in-dash mounting).
4
Connect the terminal of the car battery.
5
Press
to turn on the power.
6
Reset the unit within 5 seconds.
(
3)
Output terminals
For 2-way crossover setting
For 3-way crossover setting
KW-R925BTS
REAR
FRONT
SW
: Rear output
: Front output
: Subwoofer output
: Tweeter output
: Mid Range output
: Woofer output
KW-R920BTS
FRONT
REAR/SW
: Front output
: Rear/subwoofer output
: Mid Range output
: Woofer output
Installing the unit (in-dash mounting)
Install onto the car brackets using the supplied screws
(B)
or
(C)
. The screw holes differ
depending on the model of the cars.
Do the required
wiring. (
33
)
Dashboard of your car
Car bracket
Use only the specified screws. Using wrong screws
might damage the unit.
Part list for installation
(A)
Wiring harness
(B)
Flat head screw
M5 × 8 mm (M5 × 3/8")
(C)
Round head screw
M5 × 8 mm (M5 × 3/8")
INSTALLATION / CONNECTION
JS_JVC_KW_R925BTS_K_EN_1.indd 32
29/10/2015 9:04:57 AM
