24
ENGLISH
To change the FM tuner selectivity –
FILTER
In some areas, adjacent stations may interfere with
each other. If this interference occurs, noise may
be heard. This unit has been preset to automatically
reduce this interference noise (“AUTO”) when
shipped from the factory.
• AUTO:
When this type of interference occurs,
this unit automatically increases the
tuner selectivity so that interference
noise will be reduced. (But the stereo
effect will be also lost.)
• WIDE:
Subject to the interference from
adjacent stations, but the sound quality
will not be degraded and the stereo
effect will not be lost.
To turn on/off the key-touch tone –
BEEP
You can deactivate the key-touch tone if you do
not want it to beep each time you press a button.
When shipped from the factory, the key-touch tone
is activated.
• BEEP ON:
Activates the key-touch tone.
• BEEP OFF: Deactivates the key-touch tone.
To adjust the line input level –
LINE ADJ
Adjust the line input level properly when an external
component is connected to the LINE IN plugs.
When shipped from the factory, the line input level
is set at level “00”.
If the input level of the connected component is
not high enough, increase the input level properly.
Without adjusting the line input level, you may be
surprised at a loud sound when you change from
the external component to another source.
To make the front panel look flat (hiding the
control panel) –
PANEL
When operating the receiver using the remote
control, you can hide the control panel to make the
front panel look flat. When shipped from the factory,
“FLAT OFF” is selected.
• FLAT ON:
The control panel will not come out
when you turn on the unit.
To use the control panel, press
4
so that the control panel
comes out. If no operation is done
for about 10 seconds, it automatically
goes back into the receiver.
• FLAT OFF: You can use the control panel
normally.
EN21-26.KS-LX200R[E]f
8/30/00, 10:09 AM
24
Summary of Contents for KS-LX200R
Page 40: ...KS LX200R 3 2 MEMO ...
