Wiring connection
Metra Electronics:
www.metraonline.com
Scosche Industries:
www.scosche.com
D
Rear/subwoofer output
Join the same color wires
together.
For more information:
(separately purchased)
Vehicle-specific Wiring Harness
Make this
connection if your
vehicle factory
wiring harness does
not have “12 V
ignition switch” wire.
Separate
red wire
Fuse block
Ignition switch
Brown: Tel muting
Purple/black
Purple: Rear speaker (right)
Green/black
Green: Rear speaker (left)
Gray/black
Gray: Front speaker (right)
White/black
White: Front speaker (left)
Black: Ground
Red: 12 V Ignition switch
Yellow: 12 V Battery
Orange/white: Illumination
Blue/white: To amplifier
Blue/white:
Remote (200 mA max.)
Blue: To power antenna
Recommended
connection
Antenna terminal
Factory wiring
harness (vehicle)
Rear ground terminal
Remote
wire*
1
10 A fuse
JVC Amplifier
Signal cord*
1
*1
Not supplied for this unit.
If you have any troubles, try the following:
1
Check “Troubleshooting” (
'
page 17).
2
Reset the unit. (
'
page 2)
3
Contact (USA only)
Call: 1-800-252-5722 ( or ) visit: http://www.jvc.com
Installation/Connection
ENGLISH
ޓ
|
21
2012/12/14
ޓ
21:33:4
KD-X200_J_EN
