37
ENGLISH
SOUND ADJUSTMENTS
Performing the basic sound
settings
You can set the speaker output balance,
subwoofer output level, and input level of each
source.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step
1
again.
1
Press SEL (select) repeatedly to
show one of the basic sound setting
(SEL) screens.
Each time you press the button,
the adjustable items change as
follows:
• For DSP mode settings, see pages 32
to 34.
• For iEQ (sound mode) settings, see pages
35 and 36.
Indication
To do:
Range
Fad
Adjust the front
R06 (Rear only)
and rear speaker
|
balance.
F06 (Front only)
Bal
Adjust the left
L06 (Left only)
and right speaker |
balance.
R06 (Right only)
Sub Out
Adjust the
00 (min.)
subwoofer output
|
level and cutoff
08 (max.)
frequency level.
Low/Mid/High
BBE
Make sounds
BBE Off, BBE 1,
natural.
BBE 2, BBE 3
Vol Adj
Adjust and store
–05 (min.)
the input level
|
of each source.
+05 (max.)
SEL
2
Adjust the level.
To adjust fader and balance—Fad, Bal:
Make these two adjustments at the same
time.
• If you are using a two-speaker system, set
the fader level to “00.”
• Press
5
(up) or
∞
(down) to adjust the
fader.
• Press
¢
or
4
to adjust the
balance.
To adjust subwoofer output—Sub Out:
This takes effect only when a subwoofer is
connected.
You can also set an appropriate cutoff
frequency level according to the subwoofer
connected.
• Press
¢
or
4
to select “Low,”
“Mid,” or “High.”
Low:
Frequencies higher than 50 Hz are
cut off to the subwoofer.
Mid:
Frequencies higher than 80 Hz are
cut off to the subwoofer.
High: Frequencies higher than 115 Hz are
cut off to the subwoofer.
To increase the level.
To decrease the level.
ATT
Basic sound settings
Fad/Bal
Sub Out
Vol Adj
BBE
DSP
Canceled
iEQ
EN32-38SH9101[E_EX]f.p65
03.2.27, 23:03
37
