INSTALLATION (IN-DASH MOUNTING)
The following illustration shows a typical installation. If you have any questions or require information regarding installation kits, consult your JVC car audio dealer or a company supplying kits.
• If you are not sure how to install this unit correctly, have it installed by a qualified technician.
Removing the unit
Before removing the unit, release the rear section.
3
Do the required electrical connections.
Bend the appropriate tabs to hold the
sleeve firmly in place.
*
3
When you stand the unit,
be careful not to damage
the fuse on the rear.
When installing the unit without using the sleeve
In a Toyota car for example, first remove the car radio and install the unit in its place.
When using the optional stay
Note
:
When installing the unit on the mounting bracket, make sure to use the 8 mm-long screws. If longer screws
are used, they could damage the unit.
*
4
Not supplied for this unit.
Screw (option)
Stay (option)
Fire wall
Dashboard
Install the unit at an angle of less than 30˚.
Bracket
*
4
Flat type screws (M5
×
8 mm)
*
4
Flat type screws (M5
×
8 mm)
*
4
Bracket
*
4
Insert the two handles, then pull them as
illustrated so that the unit can be removed.
Instal1-2_DV4204_3[UI]f.indd 2
Instal1-2_DV4204_3[UI]f.indd 2
12/21/05 3:50:16 PM
12/21/05 3:50:16 PM