(No.MA446<Rev.001>)1-9
SECTION 2
SPECIFIC SERVICE INSTRUCTIONS
This service manual does not describe SPECIFIC SERVICE INSTRUCTIONS.
SECTION 3
DISASSEMBLY
3.1
Main body (Used figure are KD-AVX40J)
3.1.1 Removing the Bottom chassis (See Fig.1 to 4)
(1) Remove the two screws
A
and two screws
B
attaching the
Heat sink. (See Fig.1)
(2) Remove the one screw
C
attaching the Bottom chassis.
(See Fig.1)
Fig.1
(3) Remove the one screw
D
attaching the Bottom chassis.
(See Fig.2)
Fig.2
(4) Remove the three screws
E
attaching the Bottom chassis.
(See Fig.3)
Fig.3
(5) Remove the two screws
F
attaching the Bottom chassis.
(See Fig.4)
Fig.4
3.1.2 Removing the Main board (See Fig.5 to 8)
(1) Disconnect the card wire from Front chassis connected to
connector
CN962
of the Main board. (see Fig.5)
(2) Disconnect the connector wire from Gear bracket unit con-
nected to connectors
CN881
and
CN891
of the Main
board. (See Fig.5)
(3) Remove the two screws
G
attaching the Main board. (See
Fig.5)
Fig.5
(4) Remove the one screw
H
attaching the Rear bracket. (See
Fig.6)
A
B
C
D
E
F
F
CN962
CN891
CN881
G
