JVC HR-S8500E, Instructions Manual

Page: 41 / 68

EN
41
5 / 8
¡
1 q
6
8
T
V
–
TV PROG –
TV
+
– –:– –
1 2 3
4 5 6
7 8 9
0 X
2
4
1
3
ENGAGE INSERT EDITING
6
Press INSERT .
●
Your recorder enters the Insert-Pause mode. (" ", " "
and " " light up on the front display panel.)
●
The TV screen changes from the still picture to the
input source you are going to record.
START EDITING
7
Load the source cassette and play back the segment that
is to be inserted. When you reach the start of the
section of the source tape that you wish to insert, press
PLAY to start the tape in your recorder; Insert Editing
begins at this point.
●
" " and " " are displayed on the front display panel.
END INSERT EDITING
8
At counter "0:00:00", Insert Editing will stop automati-
cally while the tape continues running in the Play
mode. If you wish to stop Insert Editing before the
specified edit-out point, press
0000 .
FOR AV INSERT EDITING
If you want to replace the picture, Hi-Fi audio soundtrack and
normal audio soundtrack all at the same time...
... In step
6 above, after you press INSERT , press A. DUB also.
(" " and " " blink and " " lights up on the front display
panel.)
NOTES:
●
Suitable leads can be obtained from your dealer.
●
Insert editing is not possible with cassettes whose safety tab
has been removed.
●
When insert editing is performed on a tape that has been
recorded on another video recorder, the inserted portion may
appear distorted.
●
In insert editing, the recording speed (SP/LP) is determined by
the previous recording to be replaced. If the previous
recording's speed changes within a single edit, the inserted
picture will be distorted at the switching point.
●
A small portion of the recording which precedes an insert edit
may become erased.
●
Insert Editing is also possible using the rear panel AV1 IN/
OUT or AV2 IN/DECODER connector. When using these
connectors, make sure to select the correct input mode in step
2 .
A. DUB
INSERT
0000
PLAY
PLAY