three-step quick start
10
FINISH AUTO SETUP
Press
OK
button and move on to
Step 2
to check the results.
oops!
If there is a power cut or you accidentally press a button during
Auto
Setup
, turn the VCR off and then on again. Re-perform
Auto Setup
.
before you start
Check that the VCR is
turned off and no
cassette is inserted
Load the battery into the
Remote Control
Refer to the Remote
Control diagram
on pages 6–7
Unless indicated
otherwise, use the
buttons on the Remote
Control
Check that the
connection is completed
Turn on the TV
S-VHS
VCR
S-VHS
VCR
Three-Step Quick Start
Auto Setup
START AUTO SETUP
Press the
o
button. If ‘Auto’ appears on the display panel, press
OK
(or ).
what will happen?
The display panel on the front of the VCR will show the
word ‘Auto’. Do not press any button on the VCR or the Remote Control.
The VCR is automatically setting up the tuner
channels, clock, the VIDEO Plus+ system assigned
Guide Program numbers and the video channel.
This only happens the first time that the VCR is
turned on.
rf and sc art connection
If you have chosen to
connect the VCR to the TV with both the RF Cable
and a 21-pin SCART Cable (
not provided
) and the
TV set is in its AV mode (see the TV manual), you
will see the following information displayed on
your TV screen:
SELECT THE VIDEO CHANNEL
When
Auto Setup
has finished, you will see the following display panel on your VCR:
rf c able only
If you have only used the RF Cable to connect the VCR to the TV,
you will
see this display. The number is the channel on
the TV that the
Auto Setup
has chosen to be the
video channel. In the example, we have pre-
sumed that channel 52 is vacant and have set the
VCR to 52:
Now tune the TV set to channel 52 (
refer to TV manual if
necessary
); you should see two vertical white bars appear
on the TV screen. If the bars do not appear or are not
clear, choose another vacant channel pressing
PR
+
/
-
-
on
the Remote Control and try again. If you cannot obtain
the vertical white bars on any channel between 22 and 69,
consult your local JVC dealer.
rf and sc art connection
If you have chosen
to connect the VCR to the TV with both the RF
Cable and a 21-pin SCART Cable (
not provided
),
you need to press the
PR
-
-
on the Remote
Control until the figure reads ‘– –’. This is
because you will use the TV in AV mode to view video pictures and therefore do
not need a dedicated video channel.
– –:– –
Auto Setup is running:
don’t
touch any buttons
Your TV screen during Auto Setup if SCART is used
S-VHS
VCR
AUTO SET
PLEASE WAIT
[MENU]: EXIT
HR-S5975/5977EK-EN/p08-12
3/6/04, 11:15 AM
10
