6
AV1 OUT
COMP. Y/C
S OUT
(DV/VHS)
RF OUT
ANT. IN
AUDIO
OUT
(DV/VHS)
L
R
AV1 IN/OUT (L-1)
AV2 IN/DECODER (L-2)
AC IN
QUICK SET UP GUIDE (cont.)
4– Connect the provided SCART cable between the AV1 IN/OUT
socket on the rear panel of the recorder and the TV’s 21-pin
AV input connector (SCART).
5– Set the AV1 OUT switch to the appropriate position. See "AV1
INPUT/OUTPUT SIGNAL SELECTION FOR AV CONNEC-
TION" below.
STEP
2
INSTALLATION
CONNECT VIDEO RECORDER TO TV
Place the recorder on a stable, flat surface.
AV CONNECTION
To connect to a TV with 21-pin AV input connector (SCART) . . .
1– Disconnect the TV aerial cable from the TV.
2– Connect the TV aerial cable to the ANT. IN jack on the rear
panel of the recorder.
3– Connect the provided RF cable between the RF OUT jack on
the rear panel of the recorder and the TV’s aerial connector.
ATTENTION
n
Do NOT Plug the mains power cord into a mains outlet until all connections are completed.
n
Do NOT press the
button on the recorder or on the remote control to turn on the recorder's
power before you start the Auto Set Up procedure described on page 8.
21-pin AV input
connector (SCART)
Aerial connector
Back of TV
21-pin SCART Cable (provided)
RF Cable (provided)
TV Aerial Cable
(not provided)
Back of Recorder
Mains outlet
AV1 INPUT/OUTPUT SIGNAL SELECTION FOR AV CONNECTION
The AV1 IN/OUT connector accepts and delivers either a composite signal (regular video signal) or a Y/C signal (a signal in which the
luminance and chrominance signals are separated). For input signal selection, select "VIDEO" (regular video signal) or "S-VIDEO"
(Y/C signal) for "AV1 SELECT" setting (
Z
pg. 48). For output signal selection, use the AV1 OUT switch on the rear panel.
●
If your TV's 21-pin AV input connector (SCART) is compatible only with the regular video signal, set this switch to COMP.
●
If your TV's 21-pin AV input connector (SCART) is compatible with the Y/C signal, set this switch to Y/C. You can obtain high-
quality S-VHS pictures. (For connection, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.)
NOTES:
●
Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV's SCART connector.
●
For switching the TV's mode, refer to the instruction manual of your television.
●
To obtain high-quality S-VHS pictures, you can also use the S-VIDEO CONNECTION described on page 7.
AV1 OUT switch
Mains power inlet
ATTENTION:
You can not use the recorder connected to your TV only with the RF cable. This is because the RF cable does not deliver signal
from the recorder. Your TV must have a 21-pin AV input connector (SCART) to connect to the recorder.
