Cleaning the Device
When the device is dirty, wipe it with a dry silicone cloth or other soft cloth. If the device
is very dirty, remove the dirt with a cloth with neutral cleaner on it and then wipe off the
cleaner. Wiping the device with a hard cloth or using a volatile substance such as thinner
or alcohol may cause scratches, deformation, deterioration, or other damage. When the
lens is dirty, gently wipe it with a soft cloth dampened with water. Rubbing the lens strong-
ly with a dry cloth may cause scratches.
Precautions for Installation
• Install the device in a position where it will not block the front view of the driver
(position where hidden by the rear-view mirror).
• Install the device so that it is within the wiping range of the wiper.
• Install the device in a position where it will not interfere with the movement of the
rear-view mirror.
• Take care not to install the device over the vehicle inspection sticker or other sticker.
• Take care not to install the device where it will interfere with driving or airbag operation.
• When installing the device in a vehicle equipped with a driving support system, check
the instruction manual of the vehicle and then select an installation location that will
not interfere with the driving support system.
• If the device is installed incorrectly, event recording or parking recording may not work
correctly. Refer to “How to Install” for the loosening of fixing knob, installation orien-
tation, installation angle, and other information and then install the device correctly.
• Do not install the device near a digital terrestrial television antenna or an electrical
component. Doing so may reduce television receiver sensitivity or cause flickering and noise.
• Use a commercially available cleaning cloth or the like to wipe off all dirt and grease on
the mounting surface and then fix the mount base in place. If the device is re-affixed
or mounted using, for example, general-purpose double-sided tape, the adhesion
strength may weaken and cause the device to fall.
• After mounting the device, leave it for 24 hours before use to enable the mounting
strength of the mount bracket to improve. Failing to do so may result in the adhesion of
the mount bracket becoming weak and the device falling.
• Fix the cord in place with tape or the like so that it does not interfere with driving.
Correct use
The Dashcam is solely designed to be used as a Dashcam. It is only suitable for private and
not for commercial use. Only use the Dashcam as described in the Operating Instructions.
Any other use is deemed to be incorrect and can cause material damage and loss of data.
The manufacturers or dealers do not accept any liability for damage resulting from improp-
er or incorrect use.
Read and keep instructions
This Operating Instruction belong to this Dashcam. It contains important information about
the start up and handling. Study these Operating Instructions and, in particular the Safety
Information in detail prior to using the Dashcam. Non observance of these Operating Instruc-
tions can lead to loss of data or damage to the Dashcam. These Operating Instructions are
based on valid standards and regulations of the EU. Also observe specific guidelines and laws
in other countries! Keep the Operating Instructions for further use. When passing on the Dash-
cam to third parties please also include these Operating Instructions.