7
Introduction
This page is for when operating your TV using the
remote control of this product.
Setting the manufacturer's code
1
Slide the remote control mode
selector to the TV side.
2
Keep pressing down
TV.
NOTE
Keep pressing down
TV
until Step 4 is complete.
3
Press ENTER.
4
Press number buttons (1-9, 0).
Ex.:
For a Hitachi TV: Press 1, then 0.
For a Toshiba TV: Press 0, then 8.
If there are more than one manufacturer’s codes,
try them in turn and select the one that causes the
product to work properly.
NOTE
Manufacturer’s codes may be changed without notice.
You may not be able to operate a TV produced by the
manufacturer shown above.
5
Release TV.
For TV operation
Operate the remote control by pointing it towards
the TV.
*1 Make sure to slide the remote control mode
selector to the TV side in advance.
NOTE
When the batteries are replaced, perform the
manufacturer's code setting again.
Operating the TV using
the remote control
Manufacturer
Code
Manufacturer
Code
JVC
01
Samsung
12
Hitachi
10
Sanyo
13
Magnavox
02
Sharp
06
Mitsubishi
03
Sony
07
Panasonic
04, 11
Toshiba
08
RCA
05
Zenith
09
Turn ON/OFF the power.
Change channels.
Adjust volume.
Select channels.
Alternates between the
previously selected channel
and the current channel.
Switch TV and video input.
100+
9
*1
Getting started
FS-Y1[J].book Page 7 Monday, January 31, 2005 12:04 PM