30
ENGLISH
Select “ON” or “OFF.”
• If you connect high-range speakers to
Front or Rear output, select “ON” for the
corresponding HPF; otherwise, the speakers
may be damaged.
•
ON / OFF
ON
:
Activates the filter.
\
Press
to adjust
reproduced frequency level and
slope (see below).
OFF
: Deactivates the filter.
\
Press
.
“Filter Off OK?” appears, then press
again.
To select the cutoff frequency
Select an appropriate cutoff frequency level
according to speakers.
•
1.6 kHz
to
16 kHz
:
For Front HPF and Rear
LPF
•
31.5 Hz
to
200 Hz
:
For Rear HPF
To adjust the slope
Adjust the slope—continuity of sound among
speakers.
•
–18 / –12 / –6
(dB)
• As the number becomes higher, the
reproduced band width shared among
speakers becomes wider.
To adjust fader and balance
—Fad/Bal
Adjust the fader*—speaker output balance
between the front and rear speakers.
* When crossover network is activated, speaker
output balance between high-range and mid-
range speakers is adjusted.
•
F12
: Upmost—front only
•
R12
: Downmost—rear
only
Adjust the balance—speaker output balance
between the left and right speakers.
•
L12
:
Leftmost—left only
•
R12
:
Rightmost—right
only
To adjust reproduced frequency
level—Crossover
• This setting is available only when crossover
network (see page 28) is activated.
To activate the fi lters (HPF/LPF)
Select an item.
•
Front HPF / Rear LPF /
Rear HPF
• For Front HPF and Rear HPF: Frequencies
lower than the selected level are cut off.
• For Rear LPF: Frequencies higher than the
selected level are cut off.
Front HPF
:
Adjusts HPF for front speakers.
Rear LPF
:
Adjusts LPF for rear speakers.
Rear HPF
:
Adjusts HPF for rear speakers.
EN28-31_KD-SHX855[U]f.indd 30
EN28-31_KD-SHX855[U]f.indd 30
05.4.8 8:59:09 PM
05.4.8 8:59:09 PM
