Troubleshooting
If you encounter problems with this unit, check the following before requesting service.
1 Refer to “Trouble” below.
2 Refer to the “Troubleshooting” section in the “Detailed User Guide”.
If you have difficulties operating the unit, refer to the detailed descriptions in the
“Detailed User Guide”.
0
http://manual3.jvckenwood.com/index.html/
3 This unit is a microcomputer-controlled device. Electrostatic discharge, external
noise and interference (from a TV, a radio, etc.) might prevent it from functioning
properly.
In such a case, reset the unit.
A
Turn off the power. (Close the LCD monitor.)
B
Remove the AC adapter and battery pack from this unit, reattach them,
open the LCD monitor and this unit powers on automatically.
4 If the above do not solve the problem, consult your nearest JVC dealer or JVC
service center.
Trouble
Trouble
Action
Page
Power
POWER/CHARGE
lamp starts blinking
when the monitor is
closed.
0
The battery pack is being charged.
5
Recording
Recording cannot be
performed.
0
Check the
A
/
B
button.
8
0
Set to the recording mode by tapping
the
E
button.
10
Recording stops
automatically.
0
Turn off this unit, wait for a while, and
turn it on again. (This unit stops
automatically to protect the circuit
when the temperature rises.)
-
0
Recording stops automatically after
12 hours of continuous recording.
-
Unable to record
properly in the
Intelligent Auto mode.
0
When there are multiple light sources
and depending on the shooting
conditions, exposure and focus may
not be adjusted correctly in the
Intelligent Auto mode. In this case,
adjust the settings manually.
-
Playback
Sound or video is
interrupted.
0
Sometimes playback is interrupted at
the connecting section between two
scenes. This is not a malfunction.
-
14
